Rivet machine maintenance should pay attention to what?
1, do not process more than standard nominal capacity outside of work
2, don't work long hours under high pressure condition.
3, the length of the rivet head do not exceed the prescribed.
4, use the hydraulic oil should be replaced after a year.
5, radial equipment should be regularly oil lubrication.
6, meet abnormal immediately stop overhaul, straight to troubleshooting.
7 to despise and riveting head, especially when removing rivet head don't use brute force, should be riveting head rotation and slow down. If instrumentation riveting riveting was uprooted in normal position, after installation of rivet head rivet head position will appear obvious deviation, should remove red safety hood, at this time will be riveting just can use after installed, otherwise machine easily damaged.
8, the guide rail equipment should be blotted out once a month of butter, lubrication and rust.
9, use rivet head slight caking phenomenon occurs in some materials processing, in order to guarantee the quality of riveting, should be regularly to rivet head to clean, prevent metal bonding thickening. When clearing the riveting head is fixed on the lathe chuck, then polished with sandpaper.
10, radial riveting machine in the use of a month after the deal with spherical pair lubrication for processing, concrete filling method refer to the following content.
A, make sure equipment in non-working condition, shut off the power supply.
B, screw fine-tuning a screw to the top, make the red safety shield to tighten the set screw hole above.
C, with a flat head screwdriver to unscrew the bottom tight set screw.
D, butter gun nozzle on the screw hole, the internal pressure into the butter.
E, after refueling will set screw mount, tighten. If have adjust screw sleeve, and don't want to change the riveting feeding can be in only under the condition of the oil pump motor work, stepped on the foot switch to close the oil pump motor after rivet head down to the bottom dead center, and then according to the above steps 3, 4, 5 refueling rivet machine belongs to the mechanical stamping machines, debugging is good after the difficult problems.